| Step | | Procedure & Parts & Tools |
| 1 |
|
LIFT THE RECOVERY TANK FROM THE MACHINE AND CARRY TO DRAIN TO EMPTY. PUSH THE MACHINE OVER A DRAIN AND REMOVE THE YELLOW SOLUTION FILTER CAP TO DRAIN THE SOLUTION TANK.
|
| 2 |
|
RAISE THE TANK COVER UP UNTIL IT POPS OFF MACHINE.
|
| 3 |
|
LOCATE THE 2 HOSES COMING UP THRU THE SOLUTION TANK. PULL THE HOSE CUFFS OFF HOSES.
|
| 4 |
|
REMOVE THE 4 BOLTS HOLDING THE BATTERY COVER.
| Torx T30 |
|
|
| 5 |
|
SLIDE BOTH BATTERIES FROM THE BATTERY COMPARTMENT. NO NEED TO DISCONNECT THE CABLES.
|
| 6 |
|
REMOVE THE 2 BOLTS IN THE BATTERY COMPARTMENT.
| Torx T30 |
|
|
| 7 |
|
LOOSEN THE BOLT ON THE FRONT OF THE SOLUTION TANK.
| Torx T30 |
|
|
| 8 |
|
REMOVE THE 2 SOLUTION TANK BOLTS ON EACH SIDE OF THE TANK.
| Torx T30 |
|
|
| 9 |
|
RAISE THE SOLUTION TANK UP.
|
| 10 |
|
LOCATE THE CHECK VALVE AND CHECK FOR LEAKS.
|
| 11 |
|
CHECK THE HOSES AT THE T CONNECTOR FOR A TIGHT CONNECTION.
|
| 12 |
|
CHECK THAT BOTH HOSES ARE TIGHTLY CONNECTED TO THE MANIFOLD.
|
| 13 |
|
CHECK THE HOSE AT THE PUMP FOR A TIGHT CONNECTION.
|
| 14 |
|
IF ALL HOSES ARE OKAY, REVERSE STEPS 1 THRU 9 TO REASSEMBLE THE MACHINE.
|